How to clean and maintain crystal chandelier?

How to clean and maintain crystal chandelier?

A. Construction of the workbench: If there is no hydraulic automatic elevator, a simple and safe degradable work platform must be built. The height of the platform is subject to the highest point of the lamp body that can be touched by a person standing up and lifting a strange crystal chandelier. 

B. Wipe the crystal beads: When wiping the beads, be sure to have a soft cloth dipped in water diluted with detergent, and gently wipe the front and back of the crystal beads at the same time (do not pinch the beads and pull down when wiping, so as not to break the beads. string). 

C. Keep the balance of the lamp body: If you want to remove all the bead strings for clean, large lamps should pay attention to the balance of the lamp body when removing the bead strings. Do not remove one side and then the other side and cause the lamp body to tilt, causing the lamp body or exterior The frame is deformed; it should be disassembled with front, back and left. 

D. Wipe the bracket accessories: When wiping the brackets and accessories, the soft cloth should not be dipped in water, especially alcohol water, so as not to damage the protective film outside the electroplating layer and affect the surface gloss of the lamp holder. 

E. Pay attention to safe operation: When wiping the lamp holder, cut off the power supply; remove the bulb and install it after cleaning; the bulb must be screwed in properly, too loose will cause poor contact; too tight may damage the bulb. Strange crystal chandelier 

F. Replace the accessories in time: It is found that the beaded connection buckle is rusty and discolored, one is not beautiful, and the other is brittle, it is best to replace it by the way; if the bead is found to be defective, it should be filled in time.

Precautions: 

A. Do not rotate the lamp body: When cleaning the lamp, do not rotate the lamp body to avoid loosening of the screws and unsafe accidents. 

B. Check the connecting parts: The firmness of the lamp body connecting parts should be checked at the same time. If the screws are found to be loose, they should be tightened easily. The spirals with the risk of slipping should be replaced immediately to ensure safety. 

C. Keep the bead string flat: When cleaning the bead string (especially the upper and lower net parts), it is found that the bead string is twisted (this phenomenon is prone to occur with spring round buckles or oval buckles), and it should be adjusted to achieve a flat effect; if it is flat If the "butterfly buckle" is connected in series, please note that the front of the buckle should be uniformly facing outwards, and the interface should be facing inward, so as to be beautiful and unified.